Crestron-electronic TPMC-8X-BTP Manuel d'utilisateur télécharger pdf (Page 10)

Internal Battery Pack for TPMC-8X Crestron TPMC-8X-BTP

TPMC-8X Internal Battery Switch

5. Re-attach the battery compartment cover using the two supplied

Phillips head screws.

Removal

Use the following procedure to remove the TPMC-8X-BTP from a

TPMC-8X touchpanel:

1. Place the touchpanel screen-side down on a clean, soft surface.

2. Remove the two Phillips head screws that hold the internal battery

compartment cover on the rear of the touchpanel.

3. Using the flat end of a small slot head screwdriver, gently pry the

multi-pin connector off the corresponding connector in the battery

compartment of the TPMC-8X.

4. With the multi-pin connector detached from the TPMC-8X, lift the

TPMC-8X-BTP out of the battery compartment.

6 • Internal Battery Pack: TPMC-8X-BTP Operations & Installation Guide – DOC. 6556A

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Crestron-electronic TPMC-8X-BTP Manuel d'utilisateur Page 10